Weed Resistant Natural Sand for Brick Paving

For joints less than 3mm wide

Available in 2 colours: Neutral and Grey

Storage

Store product, including open bags, in a dry place. Product does not cure/harden on contact with air. Product will be adversely affected by storage in damp conditions.

Benefits

• Ready-to-use
• Quick, sweep-in application
• Weed Resistant
• Frost Resistant
• Non-polymer 100% Natural Raw Materials
• Non-Hazardous
• Non-Staining
• Water Permeable
• Certified Environmentally Friendly

Surface Preparation

Ensure that surface is clean and dry before opening the bag.

You will need a compactor/wacker plate and a leaf blower to complete the application of Joint-It Fine.

Coverage

Each bag of Joint-It Fine will cover approximately 10m of brick/block paving where the joints are less than 3mm wide.

Find out exactly how much Joint-It Fine you will need by using our calculator.

Precautions For Use

Always test a small hidden portion of the surface before use to ensure appearance and performance is acceptable. Suitable for lightly loaded surfaces (up to 3.5 tonnes).

Joint-It Fine should be applied in dry weather conditions at temperatures above 2C.

Joint-It Fine should only be used with block/brick paving laid on a water-permeable base with joints under 3mm wide.

Application Instructions

Sweep sand into clean and dry joints.

Compact sand into joints using a vibrator / whacker plate.

Use a leaf blower to remove excess sand from the top of the surface.

Wet paving with a light, fine spray and wait 5-10 minutes. Then thoroughly soak the paving.

MORE INFO:https://jointit.com/products/joint-it-fine/

PRODUCT CALCULATOR:https://jointit.com/product-calculator/